Hull & Deck Equipment
Starting from the transom area, a lazarette area with watertight door provides housing for storage and a washer/dryer. Up curved stairs (port and starboard) to the large, covered aft deck, an L-shaped settee with a beautiful teak-inlaid table and extra chairs is to port. A wet-bar is to starboard. The aft deck, stairs and swim platform are covered in teak decking.
Port and starboard wingdoors allow access to the foredeck, which features a sunpad/seating area (storage beneath) , seating and stainless steel grabrails.
The flybridge area is reached via a stairway and door from the port wheelhouse. It is truly enormous and is set up for entertaining with a grilling/bar counter (granite tops), settee to starboard and a shaded settee aft. Behind this settee is a tender and jetski. The flybridge helm has two stainless steel helm chairs covered in faux-ostrich skin. Varnished teak caprails line all of the bulwarks on the flybridge. A hinged masthead above the flybridge arched is hinged to allow for getting through lower clearances.
Note that special access plates were installed in fuel and water tanks (2008) to provide access for cleaning (2008). Sea chests in Engine room have been modified to allow pumps to be self-priming (2008).
Custom gangway from port aft deck (2008)
Tide ride boarding steps – two hinged gates port and starboard aft deck
2 bimini tops flybridge (renewed with exterior upholstery 2008)
New bow cushion stamoid cover (2011)
Kahlenburg air horns
Life rafts
Marquipt davit with full hydraulic rotation (starboard flybridge)(rebuilt 2009)
2002 Avon RIB tender with 50hp Honda outboard
2005 Seadoo RXT 4-stroke jet ski
Anchor windlass (rebuilt 2008)
Stainless steel anchor and chain
Wesmar hydraulic bow thruster – 60hp (rebuilt 2009)
Naiad stabilizers (rebuilt 2009) (serviced 2011)
Underwater exhaust system (installed 2008)
Fresh bottom job including propspeed, zincs and new cutlass bearings (6/2011)
|